1. For the full use of smart watch need to install and register in ELARI SafeFamily application on your smartphone 

2. SIM card Installation

  • Before installing a SIM card, disable the PIN code request using your phone (link to manual)
  • Before installing a SIM card, make sure that it has a positive balance and stable mobile internet. You can check it with your mobile phone (link to manual)


1. Power off the device and remove the SIM slot from the device

2. Put on the nanoSIM card with the metal contacts facing up

3. Insert the SIM slot



Also, please make sure the SIM card can connect to the internet, receive test messages, support incoming calls. KidPhone 4G supports 2G: 900/1800, 3G: 2100/900 WCDMA, 4G (B1/B3/B7/B8/B20/B38)


 3. Turn on the smart watch

  • When the smart watch detected a SIM card with a positive balance and mobile Internet, you will see the interface as in the picture below:

  • If SIM card is not installed correctly, has a negative balance or is not connected to the mobile Internet, you will see the interface as in the picture below:


 4. Сonnecting the smart watch to ELARI SafeFamily application

  • After detecting SIM card, you will see a QR code on the smart watch display
  • Open ELARI SafeFamily application-Settings-Add Device-Scan Barcode-point your smartphone camera at the QR code:



           After you scan QR code, the message “Added” will appear on the smart watch display

In ELARI SafeFamily application need to add the information about your child, SIM card mobile number which is installed in the smart watch.

Note: SIM-card number must be added in the international format without spaces, brackets and dashes + 79ххххххххх

After add the information the smart watch will be ready to work.


Link to user guide ELARI KidPhone 4G - click here

You can find answers to other questions in our knowledge base - click here

You can ask your question to our support team - click here